Rotator

Rotator Support

ERC Controller settings
When using an ERC Controller, always use this: Port: the connected com Port Protocol: Yeasu GS-232B AZ/EL or AZ (depending of your setup) Speed: 9600 (mig...
Sun, Dec 20, 2020 at 7:43 AM
Yaesu Rotor Calibration Using a Yaesu Interface
When using a Yaesu rotor (G-1000, G2800, G450, G5500, or G-800) with a Yaesu GS-232A/B interface, there are two calibrations that must be completed. This ca...
Wed, Jun 2, 2021 at 7:54 AM